If you want to create your own beautiful ribbon pin rose you will need some wire and your choice of ribbons for the rose and its petals. Begin by making a knot at one end of a 22 inches ribbon length. At the opposite end of the ribbon, poke out wire from one side and loosely gather the ribbon along this wire down to the knot.

Avoid pulling the ribbon hard, as it might snap. Continue gathering until the entire side is completely ruffled and it seems to curl naturally. Do not cut off the wire that appears at the end; leave for now free. Then, start forming a rose, by holding the knotted end in one hand and spiral the wired gathered ribbon with the other around the knot loosely. Continue rapping until it flares out and acquires an open rose effect. Then, fold the raw edge down to meet the gathered one and secure the wrapping wire end around the knot tightly. Cut the free wire off and finally, adjust the petals as needed to create the desired effect. For a leaf, fold small pieces of ribbon diagonally to the center and then fold each side towards the center to form a point. Gather bottom end and wrap it with wire, securing it onto the rose base. Your hand-made rose will certainly attract your friends' attention.

Kadence Buchanan writes articles on many topics including Women, Nursing, and Health